|
|
125 Discussion Forum
Please note: This forum is read by a wide group of 125 sailors.
This is not the place for personal attacks or inappropriate comments on anyones race, sex, age or sailing abilities.
Return to the Forum List  125 construction | At the moment I am repairing the hull of a timber 125, the area I want to repair I can access by adding an inspection port on the port side about 600mm from the transom. This will allow me to get in behind and hold the timber in place. If I was to do this does it effect the hull for future racing when measured etc
Thanks Wayne
| |
| | Re: 125 construction | I think that is the correct way to go about your repair. It will not hurt the measurement of your boat. Just a little reminder; the circumference of the bouyancy cap is usually the size of the hole you will need to cut. You can use it as a template.
| |
|
Return to the Forum List Add a message to this discussion
Measurer's Forum
Committee's Forum
|
|
